AL400ULACMCBR

Key specs

Input	Input 115VAC 60Hz rated @ 3.5A.; a) One (1) common power input for ACM8/ACM8CB and lock power (factory installed).; b) Two (2) isolated power inputs - One (1) to power the ACM8/ACM8CB and one (1) for lock accessory power, (external power supply is required). (Current is determined by the power suppl
Output	12VDC or 24VDC outputs.; 12VDC @ 4A supply current or 24VDC @ 3A supply current.; Class 2 Rated PTC protected power limited auto-resettable outputs.; Eight (8) independently controlled outputs.; Eight (8) Fail-Safe and/or Fail-Secure power outputs.; Eight (8) auxiliary power outputs (unswitched)
Features	Fire Alarm disconnect (latching or non-latching) is individually selectable for any or all of the eight (8) outputs.; a) Normally open (NO) or normally closed (NC) dry contact input.; b) Polarity reversal input from FACP signaling circuit.; Alarm output relay indicates that FACP input is triggered (
Supervision	AC fail supervision (form "C" contacts). Notification trigger is selectable for 30 seconds (factory set) or 6 hours.
Temperature	Operating 0ºC to 49ºC (32ºF to 120ºF).; Storage - 20ºC to 70ºC ( - 4ºF to 158ºF).; Relative Humidity 85% +/- 5%.; 12VDC: 25 BTU/Hr.; 24VDC: 37 BTU/Hr.
Input options	a) Eight (8) normally open (NO) inputs.; b) Eight (8) open collector inputs.; c) Any combination of the above.
Output options	Eight (8) Fail-Safe and/or Fail-Secure power outputs.; Eight (8) auxiliary power outputs (unswitched)
Output ratings	PTCs are rated @ 2.5A.; Filtered and electronically regulated outputs (built-in power supply).; ACM8 board main fuse is rated at 10A.
Battery Charging	Built-in charger for sealed lead acid or gel type batteries.; Automatic switch over to stand-by battery when AC fails.; Zero voltage drop when unit switches over to battery backup (AC failure condition).; Battery fail and battery presence supervision (form "C" contact).
BTU/Hr. (approx.)	12VDC: 25 BTU/Hr.; 24VDC: 37 BTU/Hr.
Visual Indicators	Red LEDs indicate outputs are triggered (relays energized).; Green LED indicates FACP disconnect is triggered.; AC input and DC output LED indicators.
Power supply input options	a) One (1) common power input for ACM8/ACM8CB and lock power (factory installed).; b) Two (2) isolated power inputs - One (1) to power the ACM8/ACM8CB and one (1) for lock accessory power, (external power supply is required). (Current is determined by the power supply connected, not to exceed a maxi
Fire Alarm disconnect input options	a) Normally open (NO) or normally closed (NC) dry contact input.; b) Polarity reversal input from FACP signaling circuit.

Where to buy

No retail prices for AL400ULACMCBR yet.Check retailers

Documents

altronix.comManufacturer page AL400ULACMCBR DatasheetDatasheet AL400ULACMCBR DocumentDocument AL400ULACMCBR DocumentDocument

Manuals

Install

• Installation guide · 12 pagesPDF

All manuals

Guides that use this part

No guides tag this part yet.Browse guides

Contractors certified on Altronix

Find Contractors who list a Altronix certification.Find Contractors

Q&A and reviews

Discussions 0 tagged

No discussions tagged to this part yet.

Start a discussion about this part

Reviews

No reviews yet.

Write a review