How do I add a user code on a dmp XR150

Updated Asked 1 time
Quick answer

To add a user code on a DMP XR150:

Steps

From: DMP 1100, 550, XR150 install guide, p. 1

  1. Press CMD until USER MENU? displays, select YES, then enter 99+CMD to enter the User Menu
  2. Navigate to USER CODES? and press a top-row select area to add a user code
  3. Select ADD, then select the USER NUMBER and press CMD (fourth top-row select area shows the lowest available user number)
  4. Enter a 5-digit user code and press CMD
  5. Press a top-row select area to add a USER NAME and press CMD
  6. Press CMD until USER ADDED displays

Specs & limits

From: DMP 1100, 550, XR150 install guide, p. 1

NoteUser codes are 5 digits on XR150.
NoteFor card + code, scan credential after step 3 instead of entering digits.

Applies to

XR150

Sources

  1. DMP 1100, 550, XR150 Installation guide: XR150/550 ACCESS LAB GUIDE Instructor-Led Training IDENTIFY PANEL COMPONENTS 1. Identify t (LT-2353), p. 1, p. 1
  2. DMP 1100, 550, XR150 Installation guide: XR150/550 ACCESS LAB GUIDE Instructor-Led Training IDENTIFY PANEL COMPONENTS 1. Identify t (LT-2353), p. 1, p. 1
Was this right?